![]() I checked with several 3.5 disks to be sure the problem was not caused by a bad disk.Īlso formatted a disk in this (Dell 8600) computer, then went to my old computer to copy a needed file to the 3.5 disk (which went ok), then came back to this (Dell 8600) computer, but the problem continued. 3 The operating system shows a successful operation of copying, but when you check on the diskette you find. If I press CANCEL instead of letting it continue to grind away, the message box will be cancelled, but the 3.5" drive continues to grind away, and the computer locks up, requiring a hard re-start. 2 The dikettes used are not write protected. You can't just 'plug in' something and it magically 'works'. ![]() Folks, this is not a 'plug and play' project. A few people want to read really ODD formats - hard sectored, M2FM, and so on. it will seem to go OK until the "meter" indicates that the copy is about 2/3 finished then the 3.5" drive will begin to repeatedly and noisily try to access the disk, and will eventually give up and say that the media needs to be formatted or that the file is corrupt. Some people want to read CP/M or other non-MS-DOS 5.25' or 3.5' diskettes, or old Mac 400K or 800K 3.5' Mac diskettes, on a Windows PC. the computer WILL boot from this floppy, but the drive is not fine.Ĭan anyone give me advice as to what to do?ģ.5" floppy drive can not copy a large file.Ī small file will be read from the 3.5 floppy and copied to the hard disk OK, but if the file is large. It aims to retrieve data from inaccessible floppy disks. Here is what we would like to recommend for you: BadCopy Pro. One statement was that if the computer will boot from this floppy drive, then "the drive is fine" The best solution for you to retrieve data from the floppy disk is to look for a floppy disk data recovery program to help you, instead of formatting the diskette. ![]() ![]() but the computer cannot read information from the drive. It did not consider the situation described below - which is what I sent them - where the drive is recognized. This is an older thread, you may not receive a response, and could be reviving an old thread. if not, your data is lost because the disk has lost its charge (magnetic). I presented this problem via email to Dell support and received an automated reply that considered only problems where the drive is not recognized. so long as the formatting (FAT) and disk type is compatible with XP then it should be readable.
0 Comments
Leave a Reply. |